DOS Command Diskcopy

SYNTAX

Copies the contents of one floppy disk to another.

DISKCOPY [drive1: [drive2:]] [/1] [/V] [/M]

/1	Copies only the first side of the disk.
/V	Verifies that the information is copied correctly.
/M	Force multi-pass copy using memory only.

The two floppy disks must be the same type.
You may specify the same drive for drive1 and drive2.

EXAMPLES

diskcopy a: - This would make a copy of the disk that is currently in your drive.

This page is from http://www.easydos.com. I pasted it on my website to avoid possible broken links. For further help with DOS commands, Check easydos.com out.

Contact Email: Support@upgradenrepair.com

DISCLAIMER:UpgradeNRepair (UNR), the owner, and any representatives of UpgradeNRepair (UNR) is not liable for any data loss or hardware failure because of the following procedure. The Information provided is a guide to assist the customer with an issue with their system or software. The procedures offered here may or may not harm your files. Even procedures that are not designed to harm files, can harm files, depending on the issue with the system. Because there is too many unknowns, UpgradeNRepair is unable to guarantee the safety of the files. Customer is responsible for their data and their actions. Before following the directions on this page and the pages these links are linked to, any data the customer does not want to lose will have to be saved. Saving the data is the sole responsibility of the customer. Some or all of the following procedures or information may not apply to your situation.