Creating boot disk in DOS

To create a bootdisk while you are at the command prompt insert a floppy and follow these steps....

1. Type C: then press Enter

2. Type CD Windows and press Enter

3. Type CD command and press Enter

4. Type Format A: and press Enter

5. Say Yes to the prompt

6. Type Smartdrv.exe and press Enter

7. Type Bootdisk a: and press Enter

Contact Email: Support@upgradenrepair.com

DISCLAIMER:UpgradeNRepair (UNR), the owner, and any representatives of UpgradeNRepair (UNR) is not liable for any data loss or hardware failure because of the following procedure. The Information provided is a guide to assist the customer with an issue with their system or software. The procedures offered here may or may not harm your files. Even procedures that are not designed to harm files, can harm files, depending on the issue with the system. Because there is too many unknowns, UpgradeNRepair is unable to guarantee the safety of the files. Customer is responsible for their data and their actions. Before following the directions on this page and the pages these links are linked to, any data the customer does not want to lose will have to be saved. Saving the data is the sole responsibility of the customer. Some or all of the following procedures or information may not apply to your situation.