How to install a network card

Home
About
How to use software
How to use Windows
Computer Issues
Computer parts info and install instructions
How to perform tasks and other information
Troubleshooting Tools
Remote Services
Downloads
Info on Websites and/or Businesses
Contact
I have put this website up for your convenience. The website and email service is free, but if you find this site helpful and would like to make a donation, click on the donate button above. Thank you!

How to install a network card

Read the Safety Procedures. Very Important!!!

Warning! Not following these procedures correctly can cause damage to your system. These directions are not designed to replace a qualified technician. The directions may not completely match the setup of your system due to the numerous variations of computer setups available in the market. If you not sure how to follow these directions then please consult a technician to help you. UpgradeNRepair and its representatives are not responsible for any damage.

SAFETY NOTE: Do not go in the system while any cables including power cord is connected to the system. Also drain any power to the system by pushing the power button with the power cord disconnected.

SAFETY NOTE: When you open the system, you may see dust in the system. Do not blow on it. Your breath has moisture and electronics hate moisture.

Disconnect every cable or cord that is attached to the computer. (if it is connected, disconnect it. It needs to be where you can pick up the computer and run out the door with it without no cables snatching you back)
With the power cord disconnected, push the power button and hold it in for 5 seconds VERY IMPORTANT!!! Do not put the power cord in! (This discharges any power that is still stored in the system.)
Remove the computer cover. (Consult the computer manual or manufacturer for the procedure to remove the cover.)
Remove the screw holding the card in. (some systems do not use screws but a locking mechanism to hold the card down)
lift up on the card to remove it.
Insert the new card into the slot
Screw the screw back in. (some systems do not use screws but a locking mechanism to hold the card down)
After turning system on, install the driver and/or any programs associated with the card.

Note: Some cards have wires to connect. Please consult the manual for the proper connection of the cable. Due to the numerous types of cards and different types of motherboards, I can't instruct where to plug the cables in without knowing what motherboard it is.

Contact Email: Support@upgradenrepair.com

DISCLAIMER:UpgradeNRepair (UNR), the owner, and any representatives of UpgradeNRepair (UNR) is not liable for any data loss or hardware failure because of the following procedure. The Information provided is a guide to assist the customer with an issue with their system or software. The procedures offered here may or may not harm your files. Even procedures that are not designed to harm files, can harm files, depending on the issue with the system. Because there is too many unknowns, UpgradeNRepair is unable to guarantee the safety of the files. Customer is responsible for their data and their actions. Before following the directions on this page and the pages these links are linked to, any data the customer does not want to lose will have to be saved. Saving the data is the sole responsibility of the customer. Some or all of the following procedures or information may not apply to your situation.