DOS Command Fcbs

Syntax:

FCBS=(number)

Purpose: Used in the CONFIG.SYS file to specify the number of file-control blocks (FCBs) for file sharing.

Discussion

You should only include an FCBs in your CONFIG.SYS if the program you are using requires it. Most newer programs do not use FCBs.

Option

number - Specifies the maximum number (1 to 255) of open FCBs that a program can use. The default is 4.

This page is from http://www.easydos.com. I pasted it on my website to avoid possible broken links. For further help with DOS commands, Check easydos.com out.

Contact Email: Support@upgradenrepair.com

DISCLAIMER:UpgradeNRepair (UNR), the owner, and any representatives of UpgradeNRepair (UNR) is not liable for any data loss or hardware failure because of the following procedure. The Information provided is a guide to assist the customer with an issue with their system or software. The procedures offered here may or may not harm your files. Even procedures that are not designed to harm files, can harm files, depending on the issue with the system. Because there is too many unknowns, UpgradeNRepair is unable to guarantee the safety of the files. Customer is responsible for their data and their actions. Before following the directions on this page and the pages these links are linked to, any data the customer does not want to lose will have to be saved. Saving the data is the sole responsibility of the customer. Some or all of the following procedures or information may not apply to your situation.