DOS Command Graftabl
Type: External (3.0 and later)
Syntax:
GRAFTABL [(code page)]
GRAFTABL [/status]
Purpose: Loads a table of character data into memory (used
with color/graphics adapters). (In DOS Version 6, this program is
stored on the DOS supplemental disk.)
Discussion
Used to load the table of displayable characters to those
appropriate for the specified country (when in graphics mode using a
color/graphics adapter). After using this command, the ASCII
characters 128 through 255 can be displayed in graphics mode with a
color/graphics adapter.
The normal code page is set for the United States with versions of
MS-DOS sold in the U.S.
Using the GRAFTABL command reduces the amount of available memory by
1360 bytes.
Using the GRAFTABL command resets the ERRORLEVEL code according to
the following table:
0 Code page now resident; no previous code page was set.
1 If a new code page was specified, it is now resident. There was a
code page table previously loaded; it was replaced by the current
request.
2 No code page table was previously loaded; no new table loaded.
3 Incorrect parameter; no new table loaded.
4 Incorrect version of DOS; DOS Version 3.30 required.
Options
code page The available code pages and related countries are:
437 United States
860 Portugal
863 Canada (French)
865 Norway and Denmark
/status - Displays the number of the currently selected code page.
Example
To load the GRAFTABL for Norway and Denmark, enter
graftabl 865
This page is from http://www.easydos.com. I pasted it on my website to avoid possible broken links. For further help with DOS commands, Check easydos.com out.