DOS Command Ifshelpsys

Is the 32-bit Installable File System Manager used the service provided by this driver to assist in trapping real-mode file system and network-related APIs.

It is an external file not associated with the command.com. It is available in all versions of MS-DOS, Windows 95, Windows 98, and Windows NT

SYNTAX

The following line must be put into the Config.sys

DEVICE=C:\WINDOWS\IFSHLP.SYS

ERRORS

When booting up the computer you get:

ERROR 3649: To load NetBEUI, the NDISHLP.SYS driver must be listed
in the [Network Drivers] section of the SYSTEM.INI file.

Ensure first that you are loading the IFSHLP in your config.sys file. If the file is being loaded in the config.sys then ensure that in your System.ini file that you have NDISHLP.SYS listed in the Transport= line in the [Network Drives] section.

This page is from http://www.easydos.com. I pasted it on my website to avoid possible broken links. For further help with DOS commands, Check easydos.com out.

Contact Email: Support@upgradenrepair.com

DISCLAIMER:UpgradeNRepair (UNR), the owner, and any representatives of UpgradeNRepair (UNR) is not liable for any data loss or hardware failure because of the following procedure. The Information provided is a guide to assist the customer with an issue with their system or software. The procedures offered here may or may not harm your files. Even procedures that are not designed to harm files, can harm files, depending on the issue with the system. Because there is too many unknowns, UpgradeNRepair is unable to guarantee the safety of the files. Customer is responsible for their data and their actions. Before following the directions on this page and the pages these links are linked to, any data the customer does not want to lose will have to be saved. Saving the data is the sole responsibility of the customer. Some or all of the following procedures or information may not apply to your situation.