DOS Command Loadhigh

Home
About
How to use software
How to use Windows
Computer Issues
Computer parts info and install instructions
How to perform tasks and other information
Troubleshooting Tools
Remote Services
Downloads
Info on Websites and/or Businesses
Contact
I have put this website up for your convenience. The website and email service is free, but if you find this site helpful and would like to make a donation, click on the donate button above. Thank you!

DOS Command Loadhigh

Type: Internal (5.0 and later)

Syntax:

LOADHIGH (LH) [d:][path]filename [parameters]

Purpose: Loads memory resident application into reserved area of memory (between 640K-1M).

Discussion

Tells DOS to load the specified program into the upper portion of memory. This increases the memory available for use by programs.

You can use the LOADHIGH command with the DOSKEY, DOSSHELL, KEYB, GRAPHICS, NLSFUNC, MODE, SHARE, PRINT, and APPEND commands.

NOTE:
LOADHIGH requires a computer with 350K bytes of extended memory. If you are using a computer that has a 386 or 486 microprocessor, you should specify the EMM386.EXE device driver in your CONFIG.SYS configuration file (refer to Chapter 6, Tips for Advanced Users, for more information about using the CONFIG.SYS configuration file).

Example

To load the DOS Shell into high memory, enter

loadhigh dosshell

This page is from http://www.easydos.com. I pasted it on my website to avoid possible broken links. For further help with DOS commands, Check easydos.com out.

Contact Email: Support@upgradenrepair.com

DISCLAIMER:UpgradeNRepair (UNR), the owner, and any representatives of UpgradeNRepair (UNR) is not liable for any data loss or hardware failure because of the following procedure. The Information provided is a guide to assist the customer with an issue with their system or software. The procedures offered here may or may not harm your files. Even procedures that are not designed to harm files, can harm files, depending on the issue with the system. Because there is too many unknowns, UpgradeNRepair is unable to guarantee the safety of the files. Customer is responsible for their data and their actions. Before following the directions on this page and the pages these links are linked to, any data the customer does not want to lose will have to be saved. Saving the data is the sole responsibility of the customer. Some or all of the following procedures or information may not apply to your situation.