Repair

Home
About
How to use software
How to use Windows
Computer Issues
Computer parts info and install instructions
How to perform tasks and other information
Troubleshooting Tools
Remote Services
Downloads
Info on Websites and/or Businesses
Contact
I have put this website up for your convenience. The website and email service is free, but if you find this site helpful and would like to make a donation, click on the donate button above. Thank you!

Repair

DiskPart

This is from Microsoft Technet. If you want to see it at their site, click here

To access DiskPart, click here

Applies To: Windows Vista, Windows Server 2008, Windows 7, Windows Server 2008 R2, Windows Server 2012 R2, Windows Server 2012, Windows 8

Repairs the RAID-5 volume with focus by replacing the failed disk region with the specified dynamic disk.

For examples of how this command can be used, see Examples.

Syntax: repair disk=<n> [align=<n>] [noerr]

Parameters

Parameter	Description
disk=<n>	Specifies the dynamic disk that will replace the failed disk region.
align=<n>	Aligns all volume or partition extents to the closest alignment boundary. n is the number of kilobytes (KB) from the beginning of the disk to the closest alignment boundary.
noerr	For scripting only. When an error is encountered, DiskPart continues to process commands as if the error did not occur. Without this parameter, an error causes DiskPart to exit with an error code.

Remarks

The specified dynamic disk must have free space greater than or equal to the total size of the failed disk region in the RAID-5 volume.
A volume in a RAID-5 array must be selected for this operation to succeed. Use the select volume command to select a volume and shift the focus to it.

Examples

To replace the volume with focus by replacing it with dynamic disk 4, type:

repair disk=4

Contact Email: Support@upgradenrepair.com

DISCLAIMER:UpgradeNRepair (UNR), the owner, and any representatives of UpgradeNRepair (UNR) is not liable for any data loss or hardware failure because of the following procedure. The Information provided is a guide to assist the customer with an issue with their system or software. The procedures offered here may or may not harm your files. Even procedures that are not designed to harm files, can harm files, depending on the issue with the system. Because there is too many unknowns, UpgradeNRepair is unable to guarantee the safety of the files. Customer is responsible for their data and their actions. Before following the directions on this page and the pages these links are linked to, any data the customer does not want to lose will have to be saved. Saving the data is the sole responsibility of the customer. Some or all of the following procedures or information may not apply to your situation.