How to boot to safe mode with networking

Windows 95, 98, ME

Safe mode with networking allows only the files needed to boot into windows to run and allow internet or network access. This is useful when you have an issue and need to limit what runs but yet have access to the internet.

Boot to Safe Mode with Networking

If system is on, Turn it off.
Then turn system back on
Press Function key F8 over and over again till you get the boot menu (As soon as you turn system on).

Then highlight Safe mode with Networking

Press Enter.

Highlight your operating system
Press Enter

You will see a bunch of lines on the screen

Choose Administrator.
Say Yes

Contact Email: Support@upgradenrepair.com

DISCLAIMER:UpgradeNRepair (UNR), the owner, and any representatives of UpgradeNRepair (UNR) is not liable for any data loss or hardware failure because of the following procedure. The Information provided is a guide to assist the customer with an issue with their system or software. The procedures offered here may or may not harm your files. Even procedures that are not designed to harm files, can harm files, depending on the issue with the system. Because there is too many unknowns, UpgradeNRepair is unable to guarantee the safety of the files. Customer is responsible for their data and their actions. Before following the directions on this page and the pages these links are linked to, any data the customer does not want to lose will have to be saved. Saving the data is the sole responsibility of the customer. Some or all of the following procedures or information may not apply to your situation.