DOS Command Debug

Type: External (1.0 and later)

Syntax:

DEBUG [pathname] [parameters]

Purpose: An MS-DOS utility used to test and edit programs.

Discussion

The DEBUG utility is a programmer's tool that provides access to your computer at the hardware level. More extensive information on the DEBUG utility and its functions are provided in the Technical Reference manual provided by Microsoft.

CAUTION:
Be sure that you know what you are doing when using the DEBUG utility. This is a powerful programmer's tool that can be used to gain access to your computer at the hardware level.

Click here for instructions on deleting a partition.

This page is from http://www.easydos.com. I pasted it on my website to avoid possible broken links. For further help with DOS commands, Check easydos.com out.

Contact Email: Support@upgradenrepair.com

DISCLAIMER:UpgradeNRepair (UNR), the owner, and any representatives of UpgradeNRepair (UNR) is not liable for any data loss or hardware failure because of the following procedure. The Information provided is a guide to assist the customer with an issue with their system or software. The procedures offered here may or may not harm your files. Even procedures that are not designed to harm files, can harm files, depending on the issue with the system. Because there is too many unknowns, UpgradeNRepair is unable to guarantee the safety of the files. Customer is responsible for their data and their actions. Before following the directions on this page and the pages these links are linked to, any data the customer does not want to lose will have to be saved. Saving the data is the sole responsibility of the customer. Some or all of the following procedures or information may not apply to your situation.