How to install a floppy drive

Click on the hyperlink for instructions for that step.

Read the Safety Procedures. Very Important!!!

Disconnect all cables in the back of the system (Including power cord)
With power cord removed, push the power button for five seconds (still leaving power cord disconnected)
Touch something metal on the system.
Do not blow on the inside of the system. Your breath has moisture and electronics does not like moisture.
Open the system (This hyperlink will show you a few examples, however there is too many different type of cases to show here)
locate the bay that is designed for the floppy drive. (Consult the manual, myself, or manufacturer for the instructions on the location of where the drive goes. There is too many variations of computer cases for me to give the steps here)
Some bays use clips to connect the drive in the bay, others use screws. (Check your manual myself, or manufacturer for instructions)
Most cases have a 3 1/2 slot to put a floppy. If the case you are installing the drive in doesn't have a 3 1/2 or doesn't have one free, you can install it in the 5 1/4 slot by using a kit for it.
On the motherboard there is only one controller connector for the Floppy Drive. The ribbon looks similar to an IDE cable but it is not as wide. (consult the manual, myself, or manufacturer for the exact location due to all motherboards are designed different)
Install power connector (It is designed to go in only one way and make sure it is seated good)
Close the computer up, connect keyboard, mouse, monitor and power to the system.

Contact Email: Support@upgradenrepair.com

DISCLAIMER:UpgradeNRepair (UNR), the owner, and any representatives of UpgradeNRepair (UNR) is not liable for any data loss or hardware failure because of the following procedure. The Information provided is a guide to assist the customer with an issue with their system or software. The procedures offered here may or may not harm your files. Even procedures that are not designed to harm files, can harm files, depending on the issue with the system. Because there is too many unknowns, UpgradeNRepair is unable to guarantee the safety of the files. Customer is responsible for their data and their actions. Before following the directions on this page and the pages these links are linked to, any data the customer does not want to lose will have to be saved. Saving the data is the sole responsibility of the customer. Some or all of the following procedures or information may not apply to your situation.