RunOnce tab

Home
About
How to use software
How to use Windows
Computer Issues
Computer parts info and install instructions
How to perform tasks and other information
Troubleshooting Tools
Remote Services
Downloads
Info on Websites and/or Businesses
Contact
I have put this website up for your convenience. The website and email service is free, but if you find this site helpful and would like to make a donation, click on the donate button above. Thank you!

RunOnce tab

nLite

Here is where you can add commands to run at the end of the install. If you have $OEM enabled, you can have programs on the disk that will be copied to the hard drive during the install. You then have the commands to start the programs here. For instructions on adding the files to the $OEM folder, click here

If you want to install a program that you have copied over to the install folder on C, you would type

%SYSTEMDRIVE%\install\mseinstall.exe

For instructions on how to use nLite, click here.

For questions or issues with nLite, click here

Contact Email: Support@upgradenrepair.com

DISCLAIMER:UpgradeNRepair (UNR), the owner, and any representatives of UpgradeNRepair (UNR) is not liable for any data loss or hardware failure because of the following procedure. The Information provided is a guide to assist the customer with an issue with their system or software. The procedures offered here may or may not harm your files. Even procedures that are not designed to harm files, can harm files, depending on the issue with the system. Because there is too many unknowns, UpgradeNRepair is unable to guarantee the safety of the files. Customer is responsible for their data and their actions. Before following the directions on this page and the pages these links are linked to, any data the customer does not want to lose will have to be saved. Saving the data is the sole responsibility of the customer. Some or all of the following procedures or information may not apply to your situation.