Setup network in Windows ME

Go to control panel (This link will open in a different window)
Double-click on Add/Remove Programs
Click on Windows Setup
Highlight Communications
Click on Details
Put a check in Dial-up Networking
Put a check in HyperTerminal
Click on OK

Reboot the computer
Go to control panel (This link will open in a different window)
Double-click on Network. You should have your network card, Client for Microsoft Networks, Dial-up Adapter, TCP/IP (one for each device), and File and Print Sharing.

Further information or issues

If Client for Microsoft Network is not in the list - How to add it
TCP/IP is not installed - How to add it
File and Printer sharing is not setup - Instructions on setting it up
Network identification - How to set the identification
File sharing - How to setup file sharing

What to do if you are still having issues with the network

Contact Email: Support@upgradenrepair.com

DISCLAIMER:UpgradeNRepair (UNR), the owner, and any representatives of UpgradeNRepair (UNR) is not liable for any data loss or hardware failure because of the following procedure. The Information provided is a guide to assist the customer with an issue with their system or software. The procedures offered here may or may not harm your files. Even procedures that are not designed to harm files, can harm files, depending on the issue with the system. Because there is too many unknowns, UpgradeNRepair is unable to guarantee the safety of the files. Customer is responsible for their data and their actions. Before following the directions on this page and the pages these links are linked to, any data the customer does not want to lose will have to be saved. Saving the data is the sole responsibility of the customer. Some or all of the following procedures or information may not apply to your situation.